Mypower Wind Mill

Customer’s expectations :

Light weight wings allowing low wind pick-up speeds
High tenacity, resilience and strength
Reducing costs associated with traditional wind-mill composites
Avoiding cycle time and design constraints of typical wind-mill composites
Service oriented moulder

Challenges :

Short development time (5 months for development and mould set-up)
Simple design sustaining test of time and weatherability
Rigidity at the root, limited felxibility at the tip
First industrial application of overmoulding a metallic structural sub-assembly

Results :

First Telene(r) wind mill commercial application with full technical support by moulder and Telene
Extreme low pick-up wind speed (2m/s)
Maximum deflection of tips confirmed by FEA analysis, with high safety factor
Resistance to fatigue, even in extreme wind conditions
OEM confident enough to offer 5 years warranty